gamerboi777 (December 31, 1969 at 5:59 pm)

12volts 0-6amps max read read read

gamerboi777 (December 31, 1969 at 5:59 pm)

let me know if you need an aquapulser? I have some I want to sell!

octive9 (December 31, 1969 at 5:59 pm)

I read somewhere that the resonant frequency for hydrogen was at the musical not A. I wonder if the tubes were set at that note if it would make a difference?

tutungiu (December 31, 1969 at 5:59 pm)

are you using the transformer and diodes or chock coils , if you don't ,you loose your time

theoneagain (December 31, 1969 at 5:59 pm)

acording to stanley brother that is the keylike a radio tune the arial to the rig the aerial being the tubes electron extarction happens at 11 volts -----: without electrolyte

planmix (December 31, 1969 at 5:59 pm)

I read it somewhere, but I can't remember where. Anyway.I built a new cell last weekend.It has 8 tubes. I calculated the outside surface of the inside tube to be equal with the inside suface of the outter tube. Unfortunately, nothing different happened :(

Masun (December 31, 1969 at 5:59 pm)

I don't know if this will help but, maybe you could try building a mock up of one outside tube and one inside tube fully assembled and then strike them and tune them that way? Then put them back together? I don't know if it will work. I haven't built one of these yet and you are the first one to mention how they are turnig the tubes.

planmix (December 31, 1969 at 5:59 pm)

Good luck :)

mjchauffe (December 31, 1969 at 5:59 pm)

We are trying to weld the tubes to the base to get perfect nodes and eliminate connection screws. Lets see what happens will update once we finish the fabrication.

planmix (December 31, 1969 at 5:59 pm)

I'll tell you what I did. I don't know if it's correct but it may helps you a little. At first I had to compute the surface of both tubes to be equal (2*phi*r*h).Then I hanged one tube the stoked it with a metal stick and I measured the frequency with a cymometer. If you done correct, the inner and the outter tube must have the same frequency. But I don't know what is happening when I add the screws and the wires because the frequency must be changing.If you have any ideas please let me know